If you really want to make the Pro100 taller, it should not be too difficult to make the changes:1. Build extension pieces (male/female) for the 3 pil...

How does one clean these sprayed cases, especially the inside of the neck on rifle cases? With rifle cases I wash them properly after sizing, to get a...

I find that just a few droplets per case is more than enough to smooth things up significantly.  That goes for all handgun cartridges.  No n...

I have some serious misgiving about trying to load an overbore cartridge (including the 243 Win) to subsonic velocities.  There are many opportun...

414gates.  Do you size before or after powder coating? If after, you can also try Silicone spray.If before, how on earth do you get that sticky s...

Your kit will never be complete. There will always be some tool to add for a specific task.************************************Or a better version of ...

Your kit will never be complete. There will always be some tool to add for a specific task.************************************Or a better version of ...

223, HAVE YOU EVER CONSIDERED MAKING YOUR OWN GRIPS, I HAVE MADE A FEW ALREADY AND FOUND IT ENJOYABLE AND REWARDING. THE NICE THING IS THE SMALL PIECE...

Seems perfect, but then I ask why 5.7? why not 5.56 ? why did they need a bullet that was no where measurable smaller. seems stupid to create a whole ...

What I did was I bought the spare slide stop, installed it and shot it about 100 rounds. Swapped it back and the spare sits in my range bag.  Not...

I think the video contains a lot of good info, but perhaps the info is too much for a beginner.In SA I would recommend one of the Lee kits. Choose acc...

Duplex loads are often used where the correct burn rate powder is not available.  So you use a duplex load of a faster and a slower powder to get...