Wether or not something makes a difference is entirely subjective. It only makes a difference if it makes a difference to you. A simple test on how sc...

Arken all the way.In your case, the SH4-J Gen II meets your spec at max 16x.The glass is clear enough for any distance. I've owned a couple of LX...

You need to deform the primer cup so that the priming compound breaks. This causes the ignition. Pressing on the anvil without undue force doesn'...

The primers will come out without incident. Some anvils will separate, most will be fine. You may or may not have a few misfires on those reseated. No...

I've had no issues depriming live primers with a decapping die. I have experienced misfires after re-seating them, so I don't try re-use the...

Personally, I consider accuracy as meaning no gaps on paper between successive holes at 100 meters. I also think that much of the work done on reloadi...

I'm doing the next one now with a double coating of carnuba car polish. Found some in the storage shed. Apply, let dry, wipe excess with clean cl...

.. it does not make sense that something  with less weight should cause more damage? Would that be due to the higher speed of the firing pin? in ...

Best have it cut on a lathe, If you in a hurry, a rubber backed sanding wheel on a 115mm grinder does the job. Hold it lightly against the disk for sh...

What is your OCW method? I do not shoot precision and LR shoots - the loads calculated by QL and GRT  have always served me good enough to practi...

I don't know enough about GRT to advise, but I have done enough load development to know that the computer output from GRT is just a guideline, a...