I don't know enough about GRT to advise, but I have done enough load development to know that the computer output from GRT is just a guideline, a...

I got the shortened dies back, will set them up this week.

I don't think that epoxy will survive the multi-directional stresses that are place on a rifle stock on cartridge ignition.That said, I have seen...

Lee .401 mouldDoesn't get any better than that.They come in a 4 cavity as well.Powder coat, size and shoot. It'll be necessary to see what l...

I screwed up a good needle file doeing the same on a Loadmaster shellplate for .308. 2 of the 5 stations did not feed well and caused stoppages.I cons...

How the primer punch depth adjustment can be fixed.And the grinding that was done to get the cases to all fit into the shellplate.

So far this is where it's at, the sizing dies are not back yet.One has 308 shellplate, the other for magnum boltface.Then the large primer assemb...

A silencer is caliber specific, and usually made for a particular case volume. No problem at all switching between rifles that shoot the same cartridg...

Question fot the more experienced reloaders: is there a good reason not to use the Lee case cutter system?The Lee system with case length gauges is my...

A regular spade bit 22mm.