IMO, once you become proficient, with handgun or rifle, it becomes muscle memory. Maintaining physical condition to execute that muscle memory becomes...

What is not generally understood is that it is not safe to load to below the minimum level of the load manual.Everyone understands that to go over is ...

Just for clarity sake, SEE has never been replicated. Only reported by people; usually when using reduced charges of slow powder.In conversation once ...

Avoid MS200 when the case fill is very low. This will happen in 38 and 357. The chance of a SEE with less than 50% case fill is not worth the risk.Som...

The wood is glued together, before held with coach screws. All pieces are supported, so there is no torque when the rifle is heavy.View of under-side.

I did exactly this and it did not work, so I tried epoxy and it did not work. So i tried super glue again and it worked. I then could not chamber arou...

The top piece is once fired, resized with the sizing die in it's new state. When I pull my fingernail down the neck, I feel a sharp ridge at the ...

That sounds correct, if no license was issued on that competency after the 9mm, and the 9mm was section 16.Then your competency runs till the expiry o...

I forgot to mention that should you apply for a 10 year firearm license one year before your competency expires, then your competency remains valid un...

1)  Your competency certificate expires together with the license and has to be renewed at the same time. If your competency certificate and lice...

I have factory 38 special from when they were still made with lead, I've shot a few with no issues.I had 25 ACP older than me that I shot with no...