If I were to set out to make a one off composite stock I'd go foam core. Glue up layers of high density insulation foam and carve out the stock a...

Thanks to oafpatroll for a blacksmithing video - it is time to take up the hammer again!

The owner has decided to keep it as is.

Agree. Few things beat a sensible, sober discussion around a campfire. I have nothing against getting gesous and until a recent medical road bump I�...

Groups of hungover or half drunk 'hunters' shooting things from dead rests on the back of bakkies with rifles and costumes that look like th...

How much money does someone make with a Youtube video? Would he have done everything without the media attention and income?

My renewals seldom take more than three weeks for approval, and six weeks for the license card.

When renewals are submitted, do they follow the same route as a new license application, or are they pushed from one place to the next in a different ...

Wow that little rifle has some hard miles on it. Bolt looks ok. My OCD superpower would have me dropping a couple of hundred hours of time on it. Woul...

Gedagte: hoe moontlik is dit om 'n kolf met 'n cnc masjien te laat sny? Moontlike prosesse: skandeer 'n oorspronklike een, of kry die a...

Hi Folks, The stock was probably hand made, or belonged to some other rifle. I say this because the angles are all wrong. It would certainly do better...

Wonderful initiative!I did my own and stopped somewhere around 120 animals but I cannot say all were table fare - some were culled etc.

The small things make life sweet ! Question fot the more experienced reloaders: is there a good reason not to use the Lee case cutter system? I own an...