Just be carefull about raising too much; specially with wide scope rings. Enough scopes have been damaged like that.

If it has the half-cock, hammer down one up.If no half-cock, safety on.

A pre-B does not have a half-cock. Also, the safety can only be activated when cocked. There may be some transitional models that may have a half-cock...

If it has a half-cock or firing pin block, yes. Hammer down.If it doesn't have a half-cock or firing pin block, there is no way I'll carry i...

My dream is to win the Powerball and buy a farm just to make a shooting range. Any other farm-like activities will be totally coincedental to shooting...

When it gets close to 60 days there may be sudden movement again.

With Gunsite more off than on these days, this forum may get a bit more traffic.

Here are two trajectory tables to compare.Now show a comparison between a 150gr at the usual speed and a 180gr at the usual speed.

The "datum" shoulder diameter is .400". A.40 calibre or 10mm case might work better.All these tools are comparators. Comparing one case...

Here is another mehod to give a "close enough" measurement.Size 5 cases to minimum, trim to minimum spec, load a moderate charge and shoot t...

Any idea when the 6-pack Pro will be back in stock?

Set your die up according to the following procedure.Not only will your headspace problems disappear, your cases will last longer as well and you will...

Ds JPlease describe how you set your sizing die before sizing your cases for this specific rifle and batch of cases.

Most reliable method is to take the rifle to a gunsmith to measure the headspace.Second place is to shoot the rifle as is and set the sizing die to bu...

No