Deleted because I was being a smartass and could be  misconstrued.

Q20 would probably work fine. The idea is just to get a light coating on the inside parts. I've used Balistol as well.Some solvent type spray oil...

Problem when using vinegar/peroxide mix is than it also reacts with any lead residue creating a skin-absorbable lead compound. It is also extremely ha...

The odd one out is .22LR silencers. Apparently they get very dirty very quickly. Probably because of all the lubricant used and the low pressure cartr...

If I buy a Lee progressive again, I will have to have the ability to load for all 3 calibres I own; 9mmP, .308Win and .223Rem.How much would it set me...

Do you perhaps have the drawing for a Tikka trigger?Is this what you are looking for?Do you have a drawing for the Tikke 2-stage trigger?

Ase Utra recommends spraying oil into their sealed units after use. When the weight has increased by around 100 gram (I think), to clean it in an ultr...

Do you perhaps have the drawing for a Tikka trigger?

What is an actuator?

Any idea what the velocity was?

When using iffy bullets, like PMP, that has a canelure, I have found precision and SD to get better when a roll-crimp is given into the groove. This w...

How do you adjust the mandrels?I think that most of the perceived advantages of a collet die are not limited to collet dies. Concentricity is not any ...

As far as I am aware only Forster and custom die makers produce shoulder bump dies.

I'm sure that if you check your trajectory calculations, the difference at any sane hunting distance is not as much as you may think. Add to the ...

With a 10" twist you could easily load 180gr bullets.