Do you perhaps have the drawing for a Tikka trigger?Is this what you are looking for?Do you have a drawing for the Tikke 2-stage trigger?

Ase Utra recommends spraying oil into their sealed units after use. When the weight has increased by around 100 gram (I think), to clean it in an ultr...

Do you perhaps have the drawing for a Tikka trigger?

What is an actuator?

Any idea what the velocity was?

When using iffy bullets, like PMP, that has a canelure, I have found precision and SD to get better when a roll-crimp is given into the groove. This w...

How do you adjust the mandrels?I think that most of the perceived advantages of a collet die are not limited to collet dies. Concentricity is not any ...

As far as I am aware only Forster and custom die makers produce shoulder bump dies.

I'm sure that if you check your trajectory calculations, the difference at any sane hunting distance is not as much as you may think. Add to the ...

With a 10" twist you could easily load 180gr bullets.

.308Win, .303BritAll done at 100m.

I have done load development using peep sights for most of my shooting experience over 20 years. You might be surprised how precise you can aim and sh...

No. I push through all the way then pull back all the way. Repeat that for every 3 rounds fired. For all the years I've done that, I have not onc...

To me one of the most irritating comebacks from some experienced reloaders is "just in case it makes a difference".

This is where good quality components come in. It appears that Lapua necks harden at a similar rate. Provided I do not mix my cases, neck tension seem...